(FWIW, my main issue was weird Z-heights, where say a 30mm tower would print like 2mm too tall. I’m curious if you get this to work-I gave up on Simplif圓D because it wasn’t worth fighting with such an expensive software package, but having Cura as an alternative would be nice on certain prints. I also used just a single M109 command to turn the extruder off at the end. In Simplif圓D, my only heater-related command in my start code was this: M109 S wait for extruder temp to stabilise I’m not sure why that would cause your heater to keep running, though. From here, it seems like the difference is that M109 “blocks” and waits for the temp while the M104 lets the script continue. The biggest heater-related difference I see between your start script and mine is that you’re using multiple M104 and M109 commands, while I only had a single M109. I had 99 problems but a runaway heater wasn’t one. I’m no expert, but I fought with my Cetus and G-code for a few weeks (by way of Simplif圓D). G1 Y20 E2500 F500 Extrude 25mm filament over 90mm Y axis G0 Y10 F500 Move 10mm to get rid of material G1 X2 Y178 F5000 move to back right corner Even when it is completely done with the code. Cetus 3D Printer MK3 (Four Versions) - Tiertime 3D Printer Store Sale Cetus 3D Printer MK3 (Four Versions) Rated 4.55 out of 5 based on 53 customer ratings ( 53 customer reviews) Tax not included (will be applied during checkout). The problem is that, instead of maintaining my print temp, it keeps heating up. So far I have a working start and end sequence.
0 Comments
Leave a Reply. |